What is the difference between cisco 2960 and 3560?

Meaning that you can setup VLANs but you won’t be able to route between then. 3500 series switches are L3 switches. Hence you will be able to route between VLANs. Basically between 2960 and 3560 main difference is Layer 3 capabilities on the 3560 range….ByJon.

Catalyst 2960 Catalyst 3560
WCCPv2 Yes

Can Layer 3 switches replace routers?

Although both Layer 3 switches and routers have routing functions, they cannot be equated. The router not only has routing functions, but also provides additional functions of switch ports and hardware firewalls. The purpose of the router is to make the device more applicable and more practical.

What is Cisco CNA?

Cisco® Network Assistant is a PC-based network management application optimized for wired and wireless networks for growing Small-Medium sized businesses. Cisco Network Assistant provides a centralized network view with a user-friendly GUI that simplifies configuration, management, and troubleshooting.

What is the price range for the Cisco 3560?

Get a choice of traditional, cloud managed, or full fabric-control mode–as well as a range of features, scales, port speeds, and interface types from 1G to 100G. Cisco’s fixed and modular, core, distribution, and LAN access switches have been designed for the era of intent-based networking.

How to enable IPv6 support on a Cisco 3560 switch?

– default —Set the switch to the default template to balance system resources. – routing —Set the switch to the routing template to support IPv4 and IPv6 routing, including IPv4 policy-based routing. – vlan —Maximize VLAN configuration on the switch with no routing supported in hardware.

How to reset Cisco Catalyst 3560 back to factory defaults?

– Catalyst 2940 – Catalyst 2950/2955 – Catalyst 2970 – Catalyst 3550 – Catalyst 3560 – Catalyst 3750 – Catalyst 2900XL/3500XL

How to configure the Cisco Catalyst 3560 series switches?

Ensure that the native VLAN for an 802.1Q trunk is the same on both ends of the trunk link.

  • Separate the management VLAN from the user or server VLAN,as in this diagram.
  • Do not use VLAN 1 for management.
  • Use a Layer 3 (routed) port to connect to the default gateway port.