Is there a reset button on a Hot Dawg heater?
The control will respond to an open limit and undesired flame . Lockout shall automatically reset after 1 hour . Lockout may be manually reset by removing power from the control for more than 1 second or removing the thermostat call for heat for more than 1 and less than 20 seconds .
Where is the reset button on a Modine heater?
reset button located on the switch in the top of the unit.
Do hot dawg heaters have a pilot light?
Gas is lit with an electronic igniter on call for heat.
Are Hot Dawg heaters safe?
Safety is not an issue when using the Hot Dawg. It comes equipped with several safety features such as a limit control switch, a flame rollout switch, and a pressure switch. The limit control switch will shut off the gas to the heater if the temperature exceeds a certain threshold.
Where is the model number on the Hot Dawg heater?
When ordering parts for Modine Hot Dawg Heaters please have the following ready: Model number, serial number, power code number and control code (these can be found on the serial plate on the side of the unit).
How do you reset a Modine Hot Dawg heater?
Lockout may be manually reset by removing power from the control for more than 1 second or removing the thermostat call for heat for more than 1 and less than 20 seconds.
Why is my garage heater blowing cold air?
Blower fan setting to “On” is the most common culprit for furnace blowing cold air. If by any chance you have the fan set to “Off” (we usually set it to “Off” during the summer because fans can be noisy), the air coming from the vents might be cold as well. Solution: Set the fan setting to “Auto”.
Does a Hot Dawg heater need a regulator?
Expert Reply: Yes, you should go with a dual stage like the MB Sturgis 2-Stage Propane Regulator part # 108220 for vertical or part # 108221 for horizontal because it can be adjusted to a 12″ water column outlet.
How efficient are hot dawg heaters?
An affordable way to heat your barn, garage, workshop, or warehouse, the HD Model Modine Hot Dawg Heater operates at an impressive 80% thermal efficiency. Easy to install, the heater features a direct spark ignition, low-profile design, and quiet operation.
Where is the flame rollout switch?
The flame rollout switch is used to detect if there is a fire or hot exhaust gases inside of your furnace’s burner compartment. The rollout switch is located on the side or top of the burner compartment. Most flame rollout switches look like a little metal circle with two wires coming out of the back.
Who makes Hot Dawg heater?
Modine’s
Modine’s Hot Dawg® is available in 6 model sizes, ranging from 30,000 – 125,000 BTUs. All models can run on propane or natural gas, depending on your needs. Certified for residential, commercial, and industrial use.
How Big Should the flame be on a pilot light?
A pilot flame should be blue with a yellow tip and strong enough to cover about 1/2 inch at the end of the thermocouple tip. If the flame is too strong and adjusted wrong, it will be loud and cause improper furnace operation.