How do I bypass the zone on Vista 128?

To bypass a zone on a Vista system, first enter in the Master Code (default is 1234). Then press the bypass key [6], followed by the zone number. The zone number will always be 2 digits on Vista-21iP and below panels. On Vista-128BPT and Vista-250BPT panels, the zone number will contain 3 digits.

How do I program on Vista 128?

Users must enter the programming mode to change the installer code on the Honeywell Vista 128BPT control panel. From the Vista keypad, enter into the programming mode by entering the existing 4 digit Installer Code + [8] + [0] + [0] + [0].

How do I make Vista 128bpt default?

You can factory default a Honeywell VISTA P-Series System by activating the *97 command within system programming. A factory default will reset the Master Code to 1234, reset the Installer Code to 4112, delete any other user codes, clear all programmed zones, and restore default settings.

How do I change the time on Vista 128fbp?

To set the real time clock, enter the installer code (factory default code is 4140) or the master code, followed by the pound (#) key and the numbers 63 (4140#63 without pausing between numbers).

How do I reset my Honeywell Vista security system?

How do you turn off a burglar alarm without the code?

Remove the AC power to the home alarm console from the wall directly. Use your console’s access key (or another item such as a small screw) to unlock and open the system’s backing. Lastly, disconnect at least one of the wires that are attached to the system’s main battery, which is blocky and noticeable in most units.

How do I reset the master code on a vista 128?

Complete the following steps to change the Master Code on a VISTA 128BPT:

  1. Signify a code command. On your keypad (preferably an alphanumeric keypad), enter in the following:
  2. Identify the user number.
  3. Provide the new code.
  4. Do not add new user.
  5. Confirm the new code.